Okmulgee's downtown has a large collection of historic brick commercial buildings, many with flat or low-slope roofs. Add warehouses, churches, schools and metal buildings around the county, and there are a lot of roofs that leak at seams, pond water and let summer heat pour into the building.
Spray polyurethane foam roofing, or SPF roofing, is a seamless system. High-density foam is sprayed over the prepared roof, where it fills low spots and forms one continuous layer with no seams. An elastomeric coating, usually silicone or acrylic, goes on top to protect the foam from sunlight and weather.
Foam roofing adds continuous insulation above the deck and can often go over an existing roof after repairs and moisture testing, which avoids a full tear-off. We inspect every roof first and give you a free estimate for repair, recoat or a new foam roof.
Okmulgee tip
Ask for a moisture survey before foam goes over an existing roof. Wet insulation trapped underneath can cause blisters and deck damage later.
When Spray Foam Roofing Makes Sense
- ✓Flat or low-slope commercial roofs
- ✓Built-up or modified bitumen roofs with recurring leaks
- ✓Ponding water that needs slope to drains
- ✓Metal roofs with leaking seams and fasteners
- ✓High cooling bills under a hot roof
- ✓Owners who want to avoid a full tear-off
Thickness, Coatings and Weather
Roofing foam is denser than wall foam and is usually installed at least 1.5 inches thick, often 2 to 3 inches or more to add insulation and slope. The coating is what protects the system, so coating type and thickness should be spelled out in writing.
Oklahoma hail is a real factor. Coated foam roofs can be damaged by large hail, but most damage is repairable with sealant and a fresh coat. Inspections after severe storms and a recoat every 10 to 20 years keep the roof watertight for decades.
Spray Foam Roofing Services We Offer
✓New SPF Roofs
Foam and coating over a prepared deck or existing roof.
✓Roof Recoating
Fresh silicone or acrylic topcoat for existing foam roofs.
✓Metal Roof Restoration
Sealing seams and fasteners on metal roofs.
✓Ponding Correction
Tapered foam that builds slope toward drains.
✓Storm Damage Repair
Inspection and repair after hail and wind.
Spray Foam Roofing Cost in Okmulgee, OK
| Project | Typical Range | What Affects It |
|---|---|---|
| New SPF roof with coating | $4.00–$7.00 per sq ft | Thickness, coating, roof condition |
| Recoat existing foam roof | $1.50–$3.00 per sq ft | Prep and coating type |
| Metal roof restoration | $3.50–$6.50 per sq ft | Panel and fastener condition |
| Storm repairs | Quoted per project | Extent of damage |
Planning ranges for SPF roofing. Your free estimate follows a roof inspection.
How It Works
- 1
Roof Inspection
We check drainage, decking and trapped moisture.
- 2
Prep
Wet materials are removed and edges, drains and penetrations prepared.
- 3
Foam and Coating
Foam is sprayed to thickness and slope, then coated.
- 4
Final Inspection
Thickness and drainage are checked and maintenance explained.